Plumbing referrals for Atlanta & nearby townsCall: (404) 637-2993
(404) 637-2993

Well Pump Repair in Morrow, GA

plumberatlanta.net

Morrow homes are on CCWA water. Here's what to check when pressure drops in an older house.

Weak water in Morrow?
Call now to be connected with a local plumber in Morrow.
(404) 637-2993

Morrow is one of six Clayton County cities served by the Clayton County Water Authority, so homes here don't depend on a private well pump, and we found no source counting wells. With most of Morrow's homes built before 1980, weak water usually comes from aging pipe, regulators or leaks. Call the number on this page to be connected with a local plumber in Morrow.

Worker pulling a well pump drop pipe from a well head, well pump repair in Morrow, GA

Water in Morrow

Morrow is a small, diverse city along I-75, anchored by Southlake Mall and Clayton State University and home to the Georgia Archives and the National Archives at Atlanta. CCWA supplies water from the Little Cotton Indian Creek, Shoal Creek and Pates Creek watersheds, with the Flint River as a supplemental source. The median home dates to 1971, and about 62% predate 1980, so galvanized pipe, old gate valves and worn regulators are common.

Because so much of Morrow's housing went up in the late 1960s and 1970s, many homes have had partial plumbing updates over the years, leaving a mix of old and new pipe. That can make pressure good in a remodeled kitchen and poor in an original bathroom. A plumber can trace where the old pipe still runs and recommend whether to replace a section or the whole run.

What to do now

  1. Check with neighbors. CCWA takes after-hours reports of large leaks at 770-960-5200.
  2. Run a cold tap and look for rusty water.
  3. Close every fixture and watch the meter.
  4. Look under the house for drips at old threaded joints, if you can safely reach the crawl space.
  5. Make a list of weak fixtures and when the problem started.
Call now to be connected with a local plumber in Morrow.
(404) 637-2993

Symptoms and likely causes

SymptomLikely cause
Brown water at first drawRusting galvanized pipe
Pressure worse every yearPipe narrowing inside
Weak everywhere since a repairOld gate valve stuck
Meter moving with taps closedLeak on the customer line
Drips in the crawl spaceFailing threaded joints

What affects the cost

  • Pipe condition. Old galvanized lines may need a section or full repipe.
  • Leak location. Yard versus under the house or a slab.
  • Valves and regulator. Usually quick replacements.
  • Permits. Morrow's Planning & Economic Development Department handles permits.

CCWA's service line runs from the main to the meter; the line from the meter to the house belongs to the customer. The number on this page is a free referral line, not a plumbing company; it connects you with an independent plumber who works in Morrow. Mention the age of the house and any past repiping.

Well Pump Repair questions in Morrow

Pressure fell and I'm on public water. Is a pump to blame?
No, CCWA customers have no pump. In Morrow's older homes, corroded pipe and worn valves are the usual causes.
Who do I call when the problem is the water main or the meter?
CCWA owns the line from the main to the meter; its 770-960-5200 number also takes after-hours reports of large leaks. Past the meter, call a plumber.
Can a well pump or its piping freeze during a Georgia cold snap?
Older pipe in crawl spaces is vulnerable in a hard freeze. Insulate it, close foundation vents in a cold snap and drip faucets on the coldest nights.
Is an aging pump worth repairing, or is replacement smarter?
On the rare well property, a newer pump with one failed part is repaired. An old motor with worn pipe and wiring is usually replaced together.

More plumbing services in Morrow

Well Pump Repair nearby

Call now to be connected with a local plumber in Morrow.
(404) 637-2993

Last updated:

☎ Call (404) 637-2993